At the time this video was filmed the Genesis RC Boat was priced at $192.50. Please check hobbyKing.com for actual prices as they may be subject to change. Link to Genesis RC Boat: www.hobbyking.com Linkt to HobbyKing.com Storefront hobbyking.com Specs Genesis Offshore Brushless RC Twin Hull A fiberglass hull perfectly finished and weighted as well as a powerful 100A brushless motor make this a seriously fast R/C boat. Spec. Length: 1045mm Width: 245mm Height: 115mm Weight : 2.5kg Motor: 36-74Size 2075kv Watercooled Brushless Inrunner ESC: 120A watercooled (Required) Drive system: 4mm Required. Radio System (2ch) & Receiver 1 x 3kg standard size servo 120A ESC 2ea 4000mah 2S 20C Lipo or greater
How to fix the Blade 120 SR Servo Problem. A while ago I posted a video about a problem I was having with my Blade 120 SR where the servo was juddering/jumping/shaking uncontrollably without input, this is how to fix that problem.
At the time this video was filmed the Genesis RC Boat was priced at $270.50. Please check hobbyfliterc.com for actual prices as they may be subject to change. www.hobbyking.com Linkt to HobbyFliterc.com Storefront hobbyfliterc.com Specs Genesis Offshore Brushless RC Twin Hull A fiberglass hull perfectly finished and weighted as well as a powerful 100A brushless motor make this a seriously fast R/C boat. Spec. Length: 1045mm Width: 245mm Height: 115mm Weight : 2.5kg Motor: 36-74Size 2075kv Watercooled Brushless Inrunner ESC: 120A watercooled (Required) Drive system: 4mm Required. Radio System (2ch) & Receiver 1 x 3kg standard size servo 120A ESC 2ea 4000mah 3S 20C Lipo or greater
Here's a video of a problem I've been having with my blade 120 sr. When I move the stick to make the heli pitch left and right, the servo does this juddering thing like it can't level itself out. I wanted to know if anyone knew of a way to fix this? I bought a new servo and soldered it (carefully) to the 5 in 1 board, and it works great! A side note: make sure your 5 in 1 board screws are tight and the board can not move. Update: It started happening again shortly after I replaced the servo, this time I took the servo off and bent the spokes in the back so they make better contact with the board. It seems to have worked so far.
Sure Torque united the best of two worlds. The advantages of the Sure Torque automated torque testers complement the flexibility of the manual container handling in one benchtop torque testing solution. The model in this movie measures topload and torque simultaneously to enable package designers evaluate the behaviour of the design. The machine may be configured to test all of these scenarios: 1. Thread and seal break torque measurement of CT closures (no topload). 2. Engagement and thread break testing of CR caps (adjustable topload). 3. Tamper evident bridge break torque testing of CT caps (no topload). 4. Tightening a cap on a container
